Tenda O8 5GHz CPE

CPE Tenda

Setup instructions, default access credentials, and network configuration guide.

Device Overview

The Tenda O8 is an outdoor 5 GHz 433 Mbps 802.11ac wireless point-to-point bridge with an integrated 23 dBi directional grid antenna.

It features IP65 waterproof housing, 6 kV lightning protection on the Ethernet port, and a Gigabit passive PoE interface.

Its low retail cost makes it a practical solution for farm-to-house bridges and camera surveillance backhauls.

📡

Looking for MikroTik CPEs like SXT or LHG?

MikroTik radios use Terminal and WinBox scripts rather than simple Web GUIs. See MikroTik scripts for ready-to-paste configurations.

Default IP Address 192.168.2.1

Default Credentials

User: admin | Pass: admin

How to Connect (Physical & Network Setup)

Connect the PoE port of the passive injector to the Tenda O8. Connect PC to LAN port. Assign static IP 192.168.2.10 and mask 255.255.255.0 to your PC.

Step-by-Step Configuration Steps

1 Open browser and navigate to http://192.168.2.1.
2 Log in with username 'admin' and password 'admin'.
3 In Quick Setup, choose Operating Mode: 'Station' (to connect to an AP) or 'AP' (to transmit).
4 Under Wireless Settings, select 5 GHz Channel Width and scan for the target SSID.
5 Enter the wireless encryption key and click Save.
6 Under Network Settings, configure the management IP address.
7 Reboot and aim the dish using the LED indicators on the side of the housing.

Verification Step

Verify the 3 signal LEDs on the back of the antenna feed illuminate. Check status dashboard for link RSSI.

Firmware Note: Features a 23 dBi directional grid reflector for links up to 20 km.

Menu names may vary by model and firmware version.

Report wrong info

⚠️

Notice: This is sample configuration data for field technicians and small ISPs. Verify details against official manufacturer documentation and your device casing label before applying in production.